NABAKEM - SS-1 - Cleaner - Spray can - 420ml

FEATURES
NABAKEM Resin Stripper SS#1 is a resin stripper containing strong exfoliation solvent penetrating into the resins fixated on metal mold and softening them.
It is manufactured for GRP industry. Also, the product can remove zinc stearate and vinyl resin fixed on mold surface and strips plastic dye spot.
No influence to metal surface. No residues.
Using the solvents lie aceton and MC have created many side effects.
NABAKEM Resin Stripper SS#1 has same dissolubility and cleanability without these side effects.
As pretreatment in heating process requred by other resin strippers containing water is not necessary, using finished product creates better effects.
Unlike existing solvents including aceton and MC, its vaporization speed is much slower.
It does not do any harm to human body even when inhaled.
Much lower amount is required for the same effects as existing solvents.
Therefore it is more cost-effective. With high igneous point and lower danger of fire, it reduces the costs for facilities preventing harmful materials.
(Onsite test showed that one drum of Resin Stripper SS#1 substituted from 17 drums of aceton and MC.)

USES
Following resins fixed on metal mold surface
polyacetal resins(Delrin)
polyamides (Nylon-Zytel)
polyvinylchloride resins
other resinous materials
polyvinyl formal resins
polyester (Mylar)
certain elastomers
urethanes
Manual tools
Injection system
Mixing tank
Feeder lines
Compressor
Injection mold
Automated production system

HO TO USE
Apply it sufficiently to make it penetrate into whole fixated contaminants, and leave it for about five minutes.
When it fully penetrates into contaminants , rub with cloth or tool to remove.
In case of mold for injection molding, apply with mold mounted on injection molder and tap applied surface lightly 30 minutes later.
Repetition over two or three times can remove contaminants
1. SPRAY method : Short-time spray during machinery operation removes polyacetal residues in mold, enabling you to proceed with the next work.
Recommended mold temperature is 82℃∼93℃.
As residues melt away down through eject part, apply the product three or four times for finish even after residues are removed.
2. Dipping method
3. BRUSHING method

CAUTIONS
Keep away from fire.
Do not spray it toward flame.
Do not throw empty can into fire.
Keep it in a place below 40℃.
Frequent use requires good ventilation.
Do not use it to human body.
Flush contaminated eye(s) or skin with water immediately.
This product does not belong to harmful materials subject to Toxic Chemicals Regulation Act.
Application at mold surface temperature below 100℃ does not cause fire.
Do not use it in the room using fire.